SCP DUMPS - Question and Answers Volume 3

Due to a server crash, you had to move Orion to a new server with a new IP address. Which two changes should you make to ensure that Orion functions properly from the new server and IP address? (Choose two.)

A. update the access control lists (ACLs) that restrict management protocols

B. change the IP address specified in the snmpD.conf file on the Orion server

C. updates the source address for Net Flow packets exported to Orion

D. notify ARIN of the Orion server's new IP address

E. update the destination IP address for Syslog and SNMP traps on your managed devices

Answer: A,E

You are monitoring your Internet connection, and your ISP has guaranteed512 Kbps.

Historical data shows that your connection speed holds at 256 Kbps for long periods of time, but never exceeds this speed. What does this indicate?

A. the ISP has misconfigured the link.

B. the WAN router is misconfigured.

C. the NAT table is overloaded.

D. QoS is dropping low priority traffic.

Answer: A

Your current deployment has multiple Orion NPM servers monitoring multiple locations from a single sitE. This is producing inaccurate data and high WAN bandwidth utilization. What are the two most efficient ways to address this issue? (Choose two.)

A. deploy Orion NPMat each remote location

B. deploy Orion Enterprise Operations Console

C. deploy an additional Orion Poller

D. deploy an additional Orion Web Server

E. deploy an Orion Hot Standby

Answer: A,B

How does the Orion Universal Device Poller (UnDP) monitor a device's statistics that are not included in the standard Orion NPM MIB database?

A. by manually associating the device's OID to Orion

B. by keeping a copy of the device's MIB on the Orion NPM Server

C. by automatically searching the common MIB repositories and updating Orion

D. by manually compiling the MIB into the Orion MIB database

E. by manually compiling the OID into the Orion MIB database

Answer: A

Which protocol should a network engineer enable on routers and switches to collect utilization statistics?

A. ICMP

B. SNMP

C. SMTP

D. WMI

Answer: B

A network engineer is enabling SNMP on their network devices and needs to ensure it will use message integrity.

Which version of SNMP should they use?

A. SNMPv1

B. SNMPv2c

C. SNMPv3

D. SNMPv4

Answer: C

A network engineer notices the Syslog server's database is growing significantly in size due to the large number of devices sending Syslog messages. What should the engineer do to control database growth?

A. configure the Syslog server to discard unwanted messages

B. configure the devices and the Syslog server to use TCP-based Syslog

C. configure the devices and the Syslog server to use SNMPv3

D. configure the Syslog server to capture SNMP traps instead of Syslog

Answer: A

You have recently implemented a VoIP infrastructure within the company network. You are receiving trouble tickets indicating calls are dropping between their New York and San Francisco offices. Which two IP service level agreement (SLA) measurements should you use to identify the cause of the issue?

A. latency

B. SIP

C. NetFlow

D. available bandwidth

E. jitter

Answer: A,E

Which two performance metrics can be affected by proper QoS implementation? (Choose two.)

A. jitter

B. shaping

C. marking

D. queuing

E. latency

Answer: A,E

Which network protocols are used by Solar Winds products during network discoveries?

A. ICMP and SMTP

B. DHCP and TFTP

C. PPTP and IMAP

D. ICMP and SNMP

Answer: D

Which two management protocols should you use to measure the effectiveness of your QoS implementation?

(Choose two.)

A. Syslog

B. SNMP

C. NetFlow

D. WMI

E. SSHv2

Answer: B,C

Which management protocol should you use to analyze network traffic in and out of a router interface?

A. WMI

B. Syslog

C. IP service level agreement (SLA)

D. sFlow

Answer: D

Users are complaining that a network connection is slow. How should SNMP be used to verify performance of the interface?

A. verify bandwidth usage via if InOctets

B. verify status via the if Table

C. verify that SNMP agent is responding

D. verify the performance via if Speed

Answer: A

Orion NPM is monitoring the performance of DS-3 utilizing standard MIBs in the if Table. Occasionally, the reported traffic rates for this interface spike well above45 Mbps. What is the most likely cause?

A. heavy network traffic

B. carrier misconfiguration

C. counter rollovers

D. database issues

Answer: C

Orion NPM is using SNMP to poll a router and track interface traffic rates. The data are Collected every 5 minutes, and the most recent values collected for a specific interface are 1,000,000 and 2,000,000 octets. What is the approximate average rate of traffic for this interface?

A. 1 Kbps

B. 3 Kbps

C. 16 Kbps

D. 26 Kbps

Answer: D

When using a network management system (NMS) to monitor network interfaces on a router, you notice that statistics are wrong after an interface card is physically removed from the device. What has most likely caused this problem?

A. interface re-indexing

B. device configuration

C. counter rollovers

D. access lists

Answer: A

Which two reporting requirements should you consider when specifying data roll-up settings for a network management system (NMS)? (Choose two.)

A. data encryption

B. data format

C. data granularity

D. monitoring coverage

E. data retention

Answer: C,E

Which advantage do SNMP traps and Syslog have over SNMP polling?

A. reliability of event detection

B. ability to poll events in real-time

C. ease of configuration

D. speed of event detection

Answer: D

How can you use a network management system (NMS) to ensure service level agreement (SLA) parameters are realistic for your environment?

A. increase data collection period

B. configure data summarization

C. reduce data retention period

D. baseline network performance

Answer: D

Which two management protocols should you use to measure the effectiveness of your QoS implementation? (Choose two.)

A) Syslog                                   

B) SSHv2                                  

C) SNMP                                   

D) NetFlow                     

E) WMI

Answer: D,E

A network engineer notices the Syslog server's database is growing significantly in size due to the large number of devices sending Syslog messages.

What should the engineer do to control database growth?

A) Configure the devices and the Syslog server to use SNMPv3                    

B) Configure the devices and the Syslog server to use TCP-based Syslog                      

C) Configure the Syslog server to discard unwanted messages                       

D) Configure the Syslog server to capture SNMP traps instead of Syslog

ANSWER: D

3)  Which two performance metrics can be affected by proper QoS implementation? (Choose two.
A)   latency                           

B)   marking                                     
C)   queuing                                    

D)   shaping                    

E)    jitter

Which management protocol should you use to analyze network traffic in and out of a router    interface?

A)   WMI                           
B)   sFlow                 
C)  IP service level agreement (SLA)                            
D)  Syslog 

ANSWER: B                     

Orion NPM is monitoring the performance of a DS-3 utilizing standard MIBs in the ifTable. Occasionally, the reported traffic rates for this interface spike well above 45 Mbps.

What is the most likely cause?

A)   carrier misconfiguration                       
B)   database issues                       

C)   heavy network traffic                            

D) counter rollovers

Orion NPM is using SNMP to poll a router and track interface traffic rates. The data are collected every 5 minutes, and the most recent values collected for a specific interface are 1,000,000 and 2,000,000 octets.

What is the approximate average rate of traffic for this interface?

 A)  16 Kbps                          

 B)  1 Kbps                      

 C)   26 Kbps                                    

 D)  3 Kbps